Rockwell Automation 2711E-ND1 Reference Manual PanelBuilder 1400e - Manual (Page 47)

Goto Configure Mode
Publication 2711E-6.15 – November 1998
Goto Configure Mode
This chapter shows you how to create the Goto Configure Mode
object. This object allows operators to switch the PanelView terminal
from Run Mode to Configure Mode without using the terminal’s
hardware keyswitch (where applicable). In addition, this chapter
provides tips on how to configure the Goto Configure Mode object
to avoid accidental switching of the terminal to Configure Mode.
When the operator presses the Goto Configure Mode button, the
terminal displays the Confirm Configure Mode screen.
After the operator presses OK the terminal switches from Run Mode
to Configure Mode and displays the Terminal Configuration Screen.
Pressing Cancel returns the operator to the application currently
executing on the terminal without interrupting communications or
execution of the application in any way.
About the Goto Configure
Mode Button