Rockwell Automation 2711E-ND1 Reference Manual PanelBuilder 1400e - Manual (Page 96)

90 Numerics
Publication 2711E-6.15 – November 1998
20383
MOV
MOVE
SOURCE:
N7:11
DEST: N7:12
Enter Bit
N7:10
] [
N7:10
] [
0 1
Rung for DH+ or ControlNet Application
To select the value to change, press the SELECT button on the PanelView
terminal to enable the Set Bit Cursor Point object. Use the arrow keys to
select the value, then press the Numeric Keypad Enable Button and enter
the new value.
Example 4: Numeric Input Cursor Point (for keypad terminals)
Numeric Input Cursor Point
Numeric Input Cursor Point objects change an array of values.
To select which value to change, press the SELECT button on the
PanelView terminal to enable the Numeric Input Cursor Points and to open
the scratchpad at the top of the screen. Use the arrow keys to select the
value to change, then use the Numeric Keypad to enter the data in the
window. Use the Enter key to send the data to the PLC.