Rockwell Automation 2711E-ND1 Reference Manual PanelBuilder 1400e - Manual (Page 48)

40 Goto Configure Mode
Publication 2711E-6.15 – November 1998
The screen shown below is for a 1000e or 1400e touch screen
terminal; the screen for the 1200e touch screen terminal includes an
Align Screen function. The screen includes function key labels for
1000e, 1200e, and 1400e keypad terminals.
Note: The Goto Configure Mode button switches the terminal from
Run Mode to Configure Mode only if Software Mode Switching is
enabled on the PanelView terminal’s Configure Mode Security
screen. For more information about Software Mode Switching and
about how the Goto Configure Mode button’s twin, Run Mode,
functions at the terminal, see the PanelView 1000e, 1200e, and
1400e Operator Terminals User Manual.
Important: When the terminal is switched to Configure Mode, the
application that was previously running on the terminal
is terminated and all communication with the PLC
stops. You may therefore want to put the Goto
Configure Mode button on a screen to which security
has been assigned, so an operator does not inadvertently
switch the terminal out of Run Mode.
Important: If Software Mode Switching is enabled on the
PanelView terminal’s Configure Mode Security screen,
a Goto Configure Mode button will be present on all
Major Fault windows and on the Application Transfer
screen. The Goto Configure Mode button cannot be
protected by screen security in these instances and any
operator can switch the terminal to Configure Mode.
"