Rockwell Automation 2711PC-xxxx PanelView Plus 6 Compact Terminals User Manual User Manual
Page 25
Rockwell Automation Publication 2711PC-UM002B-EN-P - April 2014
25
Install the Terminal
Chapter 2
3. Place the terminal in the panel cutout.
4. Slide the ends of the mounting clips into the slots on the terminal.
5. Tighten the mounting clip screws by hand until the gasket seal contacts the
mounting surface uniformly.
6. Tighten the mounting clips screws to a torque of 0.90…1.1 N•m
(8…10 lb•in) by using the specified sequence, making sure not to
overtighten.
Mounting Clip Slot
Mounting Clip
ATTENTION: Tighten the mounting clips to the specified torque to provide a
proper seal and to prevent damage to the product. Rockwell Automation
assumes no responsibility for water or chemical damage to the product or other
equipment within the enclosure because of improper installation.
Torque Sequence
4 Clips
2
3
1
4