Rockwell Automation 2711PC-xxxx PanelView Plus 6 Compact Terminals User Manual - Manual (Page 30)

30 Rockwell Automation Publication 2711PC-UM002B-EN-P - April 2014
Chapter 2 Install the Terminal
Connect DC Power
Follow these steps to connect the terminal to DC power.
1. Verify that the terminal is not connected to a power source.
2. Strip 7 mm (0.28 in.) of insulation from the ends of the wires.
3. Secure the DC power wires to the marked terminals (+ and –) on the
power terminal block.
4. Secure the earth/ground wire:
• On 400 and 600 terminals, secure the earth/ground wire to the
functional earth/ground terminal on the power terminal block.
• On 1000 terminals, secure the earth/ground wire to the functional
earth screw on the back of the display.
5. Apply power to the terminal.
WARNING: Explosion Hazard
Do not disconnect equipment unless power has been switched off and area is
known to be nonhazardous.
Disconnect all power before installing or replacing components. Failure to
disconnect power can result in electrical shock or damage to the terminal.
7 mm
20 mm
+ –
Earth/Ground to Ground Bus
DC - DC+
GND
DC+
DC –
Functional Earth to Ground Bus
400 or 600 Terminal 1000 Terminal