Rockwell Automation 2711PC-xxxx PanelView Plus 6 Compact Terminals User Manual - Manual (Page 32)

32 Rockwell Automation Publication 2711PC-UM002B-EN-P - April 2014
Chapter 2 Install the Terminal
After a restart, the terminal performs a series of start-up tests then takes one of
these actions:
• Launches an HMI application that is configured to run at startup.
• Launches FactoryTalk ME Station Configuration mode.
• Launches the Windows Explorer desktop.
The action that occurs depends on the start-up options configured for the
terminal. Refer to
Start-up Options on page 39
for details.
Refer to Start-up Messages and Codes on page 145 for a list of start-up
information and error messages.
Follow these steps to restart the system by using the RESET switch.
1. Insert a thin, nonconductive object into the RESET area.
2. Press and release the RESET switch.
Follow these steps to restart the system from the Windows desktop.
1. From the Start menu, choose Programs>Restart System.
You are asked to confirm the restart.
2. Click Yes to restart or No to cancel.
Follow these steps to restart the system from FactoryTalk View ME Station
software.
1. Access Configuration Mode.
Refer to Access Configuration Mode on page 33 for ways to launch
FactoryTalk View ME Station Configuration mode.
2. Press Reset [F7].
ATTENTION: User a nonconductive object to press the RESET switch. Do
not use a conducting object such as a paper clip or the tip of a pencil.
Either can damage the terminal.
FAULT
COMM
DEFAULT
RESET
FA
UL
T
FAULT
COMM
DEFAULT
RESET
FA
UL
T
COMM
FAULT
DEFAUL T
RESET
RESET
RESET