Rockwell Automation 5370-UPK CVIM USER-PAK Option - Manual (Page 14)

A–B
3
Chapter
3–1
Installation
Contents
Chapter Objectives 3–1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The Two USER–PAK Memory Cards 3–1 . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installing the USER–PAK Option 3–1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Using the Setup Card 3–4 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Accessing Setup Mode with USER–PAK Installed 3–5 . . . . . . . . . . . . . . . . .
This chapter describes how to install the USER–PAK option in the
Allen–Bradley 5370–CVIM machine vision system, including the use of the
two memory cards on which the USER–PAK option software resides.
The USER–PAK option is provided on two different memory cards. These
two cards are labeled Installation / Key card and Setup card respectively.
The purpose of each card is described below:
•
Installation / Key card – This card serves two purposes: Use this card to
install the USER–PAK option into the CVIM module. Use this card also
to access the setup mode in the case of lost passwords.
Important: Because this card can be used to override the CVIM system
security (see Chapter 4), it is suggested that this card be kept in a secure
place when not in use, and that access to this card be allowed only to the
appropriate authorized personnel.
•
Setup card – Insert this card into the Archive Memory slot after the
USER–PAK option has been installed. This card must remain in the
Archive Memory slot during setup mode in order to access most of the
USER–PAK option capabilities.
This section describes how to install the USER–PAK option.
Installing More than One Option: The USER–PAK option is entirely
compatible with any of the other CVIM option packages. You can install
the option packages in any order, with this exception – you must install
the MATH–PAK option before installing the USER–PAK option.
Installing the MATH–PAK option after installing the USER–PAK option
nullifies the USER–PAK option; if this happens, you must reinstall the
USER–PAK option.
Required Firmware: The CVIM system must have the Revision C03 (or
higher) firmware before the USER–PAK option can be installed (the
Chapter Objectives
The Two USER–PAK
Memory Cards
Installing the USER–PAK
Option