Rockwell Automation 5370-UPK CVIM USER-PAK Option - Manual (Page 27)

Chapter 4
Getting Started / Using the Security Levels
4–9
To enter the setup mode using the Installation / Key card, complete these
steps:
•
If the CVIM module is in setup mode, go to run mode.
•
Insert the Installation / Key card into the Archive Memory slot on the
CVIM module.
•
Pick the Setup box on the runtime menu to display the password entry
keyboard (Note: If Security has been set to OFF , hold the tip of the light
pen down upon the Setup box until the keyboard appears. If you are using
a mouse, place the cursor over the
Setup box, and hold the left mouse
button until the keyboard appears).
•
Enter the 3–character default password A–B on the password entry
keyboard, and pick the Ret key.
After entering the setup mode at the ADMINISTRATOR level, it is possible
to change the password for the ADMINISTRATOR level – or any other
level. While the Installation / Key card is inserted, the default password
A–B can be used as the “old password” when changing passwords (see
“Changing Passwords” earlier in this chapter).