Rockwell Automation 5370-UPK CVIM USER-PAK Option - Manual (Page 54)

Chapter 7
Creating Custom Runtime Displays
7–3
This section describes the initial steps to use in defining a viewport. To
define a viewport:
•
Insert the Setup card into the Archive Memory slot on the CVIM module.
•
Pick the Env.
→
Config. Output boxes to display the Config. Output
menu; this also displays the viewport (if a viewport is currently selected):
Viewport Border
Viewport 1 selected
Config. Output box selected
•
Select the specific viewport you are going to define using the
corresponding
Previous/Next boxes. The selected viewport appears on
the screen.
Picking the Next box repeatedly cycles though the selection of Viewports
1–40 , then Serial Port A , Serial Port B , then Viewports 1–40 , etc.
Picking and holding the Next or Previous box causes the Define
Viewport number to increment/decrement continually.
Tool Display Setting: With the Env.
→
System
→
Tool Display: box set
to ON , all viewports are displayed which have an assigned display page
and number in common with the currently selected viewport. With Tool
Display: box set to OFF , only the current viewport is displayed (see
“Selecting Display Pages and Page Numbers” in this chapter).
Initial Setup: Selecting and
Defining the Viewport