Rockwell Automation 5370-UPK CVIM USER-PAK Option - Manual (Page 24)

Chapter 4
Getting Started / Using the Security Levels
4–6
For example, if a particular password is used for both the
ADMINISTRATOR and MANAGER levels, using that password will access
the ADMINISTRATOR level. This means, in this case, the MANAGER
level will not be accessible.
Default Password: When first installed, the USER–PAK option assigns the
default 3–character password A–B to all three security levels. Before you
can access each different security level, you must assign a unique password
to each level.
Note: It is suggested, for greater security, that the passwords for the
respective security levels be changed as soon as possible upon installing
the USER–PAK option.
Effect of Password Change: After changing a password, the new password
is immediately stored in non–volatile memory; the next time you want to
enter the setup mode at the security level for which you have just changed
the password, you must use the new password.
To change a password:
•
Pick Env.
→
Change Password to access the Password Level menu
and display the keyboard:
Password keyboard
Security level selected
•
Pick the security level – Administrator , Manager , or User – for which
you are changing the password, on the Password Level menu.
•
Enter the old (current) password for the selected level, or the
ADMINISTRATOR level password, using the password keyboard, and
then pick
Ret .
•
Enter the new password, and pick the Ret key.