Rockwell Automation 5370-UPK CVIM USER-PAK Option - Manual (Page 16)

Chapter 3
Installation
3–3
The top three LEDs on the CVIM module indicate the progress of the
three–phase loading process, as follows:
LEDs
USER–PAK Loading Phase
LEDs
1 2 3
Pass/Fail
Red–to–yellow–
to–green
Green
Red–to–yellow–
to–green
Trigger 1 Green Green Off
Trigger 2 Off Green Green
The loading process requires about 45 seconds, with each phase taking
about 15 seconds. When the loading process is complete, the CVIM
module begins its normal powerup sequence.
•
Verify that the USER–PAK option is installed by checking the title banner
on the monitor after power–up; if the USER–PAK option is installed,
there is a message on the banner indicating the presence of the
USER–PAK option.
•
Remove the Installation / Key card from the Archive Memory slot.
Card Security: Because the Installation / Key card can be used to
override the CVIM system security (see Chapter 4), it is suggested that
this card be kept in a secure place when not in use, and that access to this
card be allowed only to the appropriate authorized personnel.