Rockwell Automation 5370-UPK CVIM USER-PAK Option User Manual

Page 15

Advertising

Chapter 3

Installation

3–2

firmware revision is listed on the title banner on the monitor screen
following powerup).

One–Time Installation: You need only install the USER–PAK option once;
once installed, the USER–PAK option remains installed for all subsequent
powerups.

To install the USER–PAK option in your CVIM module:

•

Remove DC power from the CVIM module by pulling out the DC PWR /
LOCK handle on the power supply module as far as it will go.

•

Insert the Installation / Key card into the Archive Memory slot on the
CVIM module. Insert the end with the metal strip facing right:

ЗЗЗЗ

CVIM Module

Card Label

Metal Strip

USER–PAK
Installation/Key card

•

Push in the DC PWR / LOCK handle as far as possible. This applies DC
power to the CVIM module, and starts the loading sequence.

Do not remove power to the CVIM module during loading

of the USER–PAK option. Doing so may damage the
CVIM module.

CAUTION:

Advertising