Rockwell Automation 5370-UPK CVIM USER-PAK Option - Manual (Page 17)

Chapter 3
Installation
3–4
To access most, but not all, of the USER–PAK features while in setup mode,
the Setup card must be inserted.
To insert the Setup card:
•
Insert the Setup card into the Archive Memory slot on the CVIM module
with the card’s metal strip facing right.
•
Leave the Setup card in the Archive Memory slot as required during your
configuration of the CVIM module.
Setup Card Requirement: Most USER–PAK features require the Setup
card be inserted; the only features which do not require the Setup card are
Change Password (see Chapter 4), and the Copy and Paste feature for
tools (see Chapter 9). When the Setup card must be inserted to access a
feature, this is specifically stated within the description of the feature in this
manual.
Removing the Setup Card: You may remove the Setup card from the
CVIM module at any time – except when the Memory Active LED on the
CVIM module is ON. The Memory Active LED goes ON during setup mode
when certain USER–PAK features are used.
Do not remove the Setup card from the Archive Memory slot
when the Memory Active LED on the CVIM module is ON.
Doing so will cause the CVIM module to shut down, which
will result in the loss of your working configuration (the
internally–stored configuration is not effected).
CAUTION:
Restarting the CVIM module: If the CVIM module operation has shut
down due to Setup card removal with the Memory Active LED ON, restart
the CVIM module when appropriate by cycling CVIM module power off and
on again.
Using the Setup Card