Rockwell Automation 5370-UPK CVIM USER-PAK Option - Manual (Page 82)

Chapter 8
Defining Strings for Serial Ports and Viewports
8–6
Table 8.A (pt. 3 of 3)
Data Codes
Data Code 1 Subcodes (.s) 1 Description of field
Sn s 2
Sn (no subcode) The number of samples.
Sn.s 2
(n=1–56,
)
Sn.1 The minimum value. ( 56,
or #)
Sn.2 The maximum value.
(F St ti ti )
Sn.3 The mean value.
(For Statistics)
Sn.4 The standard deviation value.
Fn (no subcode) Value of the formula result.
3
Fn.20 Total fault count for the formula.
Fn.s 3
(n=1–56
Fn.21 Lower fail limit for the formula.
(n=1–56,
or #) Fn.22 Lower warning limit for the formula. or #)
(For Formulas)
Fn.23 Upper warning limit for the formula.
(For Formulas)
Fn.24 Upper fail limit for the formula.
Fn.25 Nominal (learned) value for the formula.
1 The letter n = tool number; .s = subcode number.
2 Where n = 1–56, or #. The letter n specifies the formula number, if the formula of that number is enabled (the MATH –PAK option
package, Cat. No. 5370–MPK, must be installed to use formulas). Otherwise, the letter n specifies the tool number and type, as follows:
For n = 1–8 – n specifies: windows 1–8, respectively.
For n = 9–16 – n specifies: gages 1–8, respectively.
For n = 17–24 – n specifies: windows 9–16.
For n = 25–32 – n specifies: gages 9–16.
For n = 33–40 – n specifies: windows 17–24.
For n = 41–56 – n specifies: gages 17–32.
3 The MATH–PAK option package (Cat. No. 5370–MPK) must be installed, and respective formulas enabled, in order for any of the
“formula” codes to provide formula data.