Create cip symbolic program (write), Build the code – Rockwell Automation 2080-LC50 Micro800 Controllers: Getting Started with CIP Client Messaging User Manual
Page 14
8
Rockwell Automation Publication 2080-QS002A-EN-E - April 2013
Chapter 2 Use CIP Symbolic Client Messaging
Create CIP Symbolic Program (Write)
At the end of these instructions, you should have created the following program in Connected Components Workbench in
your Controller A project.
Build the Code
1. Open the project you created for
Controller A in the last chapter
through Connected
Components Workbench.
2. Configure the IP address, subnet
mask and gateway of Controller
A as shown.
RUNG 1
Use COP instruction to convert value
’ValueToWrite’ to ’A_Data’ (USINT[1...4]) which
will be used in message instruction
RUNG 2
If COP instruction is successful then trigger
’WriteValue’ to coil
RUNG 3
Send message to Controller B
IP Address:
192.168.1.18
Subnet Mask:
255.255.255.0
Gateway Address:
192.168.1.1