Rockwell Automation 2080-LC50 Micro800 Controllers: Getting Started with CIP Client Messaging - Manual (Page 8)

2 Rockwell Automation Publication 2080-QS002A-EN-E - April 2013
Where to Start
Follow These Steps
The major subsections for this quick start project are outlined in the following flowchart. Follow the steps under each
subsection to become familiar with the required procedure to configure your controller, set up a sample project, and create
programs for CIP messaging.
Use CIP Symbolic Client Messaging
See page 7
Create CIP Symbolic Program (Write) on page 8
Configure Controller B on page 14
Use CIP Generic Client Messaging
See page 23
Create CIP Generic Message Program on page 24
Configure Controller B on page 30
See the Results on page 15
See the Results on page 30
Create CIP Symbolic Program (Read) on page 16
Configure Controller B on page 21
See the Results on page 22
Create CIP Generic Message Program:
Single Controller on page 31
See the Results on page 34
TIP Download the Sample Code
You can download the sample code for the programs used in this Quick Start from the following link:
http://www.rockwellautomation.com/go/scmicro800