Rockwell Automation 2080-LC50 Micro800 Controllers: Getting Started with CIP Client Messaging - Manual (Page 37)

Rockwell Automation Publication 2080-QS002A-EN-E - April 2013 31
Use CIP Generic Client Messaging Chapter 3
Create CIP Generic Message Program: Single Controller
The previous program illustrated how a read instruction is sent from Controller A to Controller B using the
MSG_CIPGENERIC function block. This section shows how a controller queries its own catalog number using the same
function block.
At the end of these instructions, you should have created the following program in Connected Components Workbench in
your Controller A project.
Who Am I?
This is 2080-LC50-48QVB
RUNG 1
Use MSG_CIPGENERIC to retrieve catalog
information
RUNG 2
Use COP to convert the catalog information into
human readable string