Rockwell Automation 2LW3000 LonWorks Communication Option Module for VTAC 7 Drives - Manual (Page 28)

3-14 LonWorks Module for VTAC 7 Drives
Step 5.5 Reinstall the cover. Align all cover screws into the heat sink before
tightening any of them.
To maintain the integrity of NEMA 4X/12 drives, sequentially tighten the
cover screws to ensure even compression of the gaskets. Do not exceed
2.2 Nm (20 in-lb) of torque on these screws.
Figure 3.6 – 1 to 20 HP @ 230 Volt Drive
Keypad Bracket
Regulator Board
Terminal Strip
Power Terminal
Strip