Rockwell Automation 2LW3000 LonWorks Communication Option Module for VTAC 7 Drives - Manual (Page 44)

4-2 LonWorks Module for VTAC 7 Drives
4.3 Applying Power
Step 1. Close the drive cover or re-install the cover on the drive.
Step 2. Apply power to the drive. The module receives its power from the connected
drive. (Check LEDs on VTAC?)
Step 3. Apply power to the other devices on the network.
When to press service pin?
!
ATTENTION: Unpredictable operation may occur if parameter settings
and switch settings are not compatible with your application. Verify that
setting are compatible with your application before applying power to the
drive. Failure to observe these precautions could result in severe bodily
injury or loss of life.