Rockwell Automation 2LW3000 LonWorks Communication Option Module for VTAC 7 Drives - Manual (Page 45)

Installing the Drive as a Node in the Network 5-1
C
HAPTER
5
Installing the Drive as a Node
in the Network
The module is installed as a node in the LonWorks network using a standard
LonWorks installation tool such as LonMaker for Windows. Refer to the tool-specific
instruction manual for more information.
To identify the drive to the network, press the service pin shown in figure 5.1. (When to
do this? Should this be part of chapter 4? How do you verify the results of
pressing the pin?)
When you have completed this procedure, re-install the drive cover.
!
ATTENTION: This procedure requires power be applied to the drive and
the network while the cover is off of the drive. The user is responsible
for ensuring safe conditions for operating personnel. Failure to observe
this precaution could result in severe bodily injury or loss of life.
Figure 5.1 – Location of the Service Pin on the LonWorks Module
Service Pin