Assign network parameters without a dhcp server – Rockwell Automation 1768-EWEB EtherNet/IP Web Server Module User Manual User Manual
Page 35
Publication ENET-UM527E-EN-P - October 2006
Configure a Network Address For a Web Server Module 35
Assign Network
Parameters Without A
DHCP Server
If a DHCP server is not available, you must assign a static IP address
to the module. Select one of these methods:
After using one of these utilities, select Administrative Settings
>
Device Configuration
> Network Configuration to set additional
parameters.
If You Are Working in These Conditions
Use This Method For Assigning Network
Parameters
See Page
In any condition, the Rockwell Automation BOOTP/DHCP
utility is recommended.
Rockwell BOOTP/DHCP utility
(available with RSLinx and RSLogix 5000 software)
The module is connected to other NetLinx networks.
RSLinx software
The RSLogix 5000 project is online with the controller that
communicates to or through the web server module.
RSLogix 5000 software