Rockwell Automation 1768-EWEB EtherNet/IP Web Server Module User Manual - Manual (Page 36)

Publication ENET-UM527E-EN-P - October 2006
36 Configure a Network Address For a Web Server Module
Use the Rockwell Automation BOOTP/DHCP Utility
The module ships with DHCP enabled. The BOOTP/DHCP utility is a
stand alone program that lets you interactively define the IP address of
a module that is issuing DHCP or BOOTP requests. The utility is
located in the:
• BOOTP-DHCP Server folder in the Rockwell Software program
folder on the Start menu.
The utility is automatically installed when you install
RSLinx software.
• Tools directory on the RSLogix 5000 installation CD.
To use the BOOTP/DHCP utility:
1. Launch the BOOTP/DHCP software.
In the Request History panel you see the hardware addresses of
modules issuing requests.
2. Double-click on the hardware (MAC) address of the module you
want to configure.
IMPORTANT
Before you start the BOOTP/DHCP utility, make sure you have the
hardware (MAC) address of the web server module. The hardware
address is on a sticker located on the side of the module. The
hardware address in a format similar to: 00-0b-db-14-55-35.