Rockwell Automation 1768-EWEB EtherNet/IP Web Server Module User Manual - Manual (Page 40)

Publication ENET-UM527E-EN-P - October 2006
40 Configure a Network Address For a Web Server Module
5. Select Properties.
6. Select the Port Configuration tab and specify the IP address and
the other network parameters, if needed.
7. Click Apply.
8. Click OK.
This sets the IP address in the hardware. This IP address should
be the same IP address you assigned under the General tab.
On this screen, you can also specify port speed (10 Mbps or
100 Mbps) and duplex mode (autonegotiate, half duplex, or full
duplex). The module configuration needs to agree with how the
switch is configured. See your network administrator for more
information.
Duplicate IP Address
Detection 1756-EWEB modules with firmware revision 2.2 or later support
duplicate IP address detection.
All 1768-EWEB module firmware revisions support duplicate IP
address detection.
For more information about EtherNet/IP modules that support
duplicate IP address detection, see the EtherNet/IP Modules in
Logix5000 Control Systems User Manual, publication
ENET-UM001.