Rockwell Automation 1768-EWEB EtherNet/IP Web Server Module User Manual - Manual (Page 76)

Publication ENET-UM527E-EN-P - October 2006
76 Send Email
0x11 None Reply data too large. The Destination string must reserve space for the SMTP server
reply message. The maximum reply can be 470 bytes.
0x13 None Configuration data size too short. The Source Length is less than the Source Element
string size plus the 4-byte length. The Source Length must equal the Source Element
string size + 4.
0x15 None Configuration data size too large. The Source Length is greater than the Source Element
string size plus the 4-byte length. The Source Length must equal the Source Element
string size + 4.
0x19 None Data write failure. An error occurred when attempting to write the SMTP server address
(attribute 4) to non-volatile memory.
0xFF 0x0100 Error returned by email server; check the Destination string for reason. The email
message was not queued for delivery.
0x0101 SMTP mail server not configured. Attribute 5 was not set with a SMTP server address.
0x0102 “To:” address not specified. Attribute 1 was not set with a “To:” address AND there is
not a “To:” field header in the email body.
0x0103 “From:” address not specified. Attribute 2 was not set with a “From:” address AND
there is not a “From:” field header in the email body.
0x0104 Unable to connect to SMTP mail server set in Attribute 5. If the mail server address is a
hostname, make sure that the device supports DNS, and that a Name Server is
configured. If the hostname is not fully qualified, i.e., “mailhost” and not
“mailhost.xx.yy.com” then the domain must be configured as “xx.yy.com”. Try “ping
<mail server address>” to insure the mail server is reachable from your network. Also
try “telnet <mail server address> 25” which attempts to initiate a SMTP session with
the mail server via telnet over port 25. (If you connect then enter “QUIT”).
0x0105 Communication error with SMTP mail server. An error occurred after the initial
connection with the SMTP mail server.
See the ASCII text following the error code for more details as to the type of error.
0x0106 SMTP mail server host name DNS query did not complete. A previous send service
request with a host name as the SMTP mail server address did not yet complete. Note
that a timeout for a DNS lookup with an invalid host name can take up to 3 minutes.
Long timeouts can also occur if a domain name or name server is not configured
correctly.
Error Code (Hex) Extended-error
Code (Hex) Description