Rockwell Automation 1768-EWEB EtherNet/IP Web Server Module User Manual - Manual (Page 39)

Publication ENET-UM527E-EN-P - October 2006
Configure a Network Address For a Web Server Module 39
6. Select the Port Configuration tab.
7. In the Network Configuration box, click Static to permanently
assign the configuration.
If you select Dynamic on a power cycle, the controller clears the
current IP configuration and will again begin sending requests.
8. Enter the IP address and the other network parameters, if
needed.
Use RSLogix 5000 Software to Configure the IP Address
To use RSLogix 5000 software to configure the IP address:
1. Make sure the module is installed and powered up.
2. Connect to the controller via a serial or other network
connection.
3. Start RSLogix 5000 software.
4. In the Controller Organizer, select the EtherNet/IP module and
right-click.