10 height control connections, Height control connections -11, Auto-cut 200 xt – Tweco 200 XT Auto-Cut 400V User Manual
Page 35
AUTO-CUT 200 XT
Manual 0-5284
INSTALLATION
3-11
3.10 Height Control Connections
The terminal strip has Arc Volts (-) connection to power supply negative output TORCH terminal, Arc Volts
(+) connection to power supply positive output WORK terminal. These are for a height control that requires
connection to the full non-divided arc voltage. Also available on the terminal strip are 120VAC and 24 VAC.
Note that the two 0’s are not common. The allowable current draw is 100ma @ 120VAC and 1Amp @ 24 VAC.
Art # A-11900
24 VAC
@ 1A
TB4
1
2
3
4
5
6
7
120 VAC
@ 100 ma.
Work
Tip Volts
(Pilot)
Arc Volts
(Torch)
Art # A-11954
There is also a hole added in the rear panel above the receptacle for customer wiring. This, rather than the one
in the CCM will be the preferred place for customer added wiring (and strain relief) for connections to height
controls, etc..