Wheatheart X160 Series - Manual (Page 135)

W HEATHEART - G RAIN A UGERS 7. M AINTENANCE AND S TORAGE
X160-85, X160-105, X160-125
30875 R0 135
7.5. POWER SWING
7.5.1. P OWER S WING M AINTENANCE
7.5.2. P OWER S WING S TORAGE
T
O PREPARE THE POWER SWING FOR SEASONAL STORAGE
1. Raise wheels to full up position.
2. Clean out axle assembly and lubricate chains with a light coating of oil.
3. Inspect unit for damage and note any repairs required. Order replacement
parts from your dealer.
4. Check tire pressure and inflate to 24 psi (165 kPa).
P OST - STORAGE PRE - OPERATIONAL CHECKS
1. Check tire pressure and inflate according to recommendation on side wall if
necessary.
2. Keep decals clean. Replace any decal that is damaged or not clearly visible.
3. Conduct general maintenance procedure before using auger.
Important:
Use only genuine Westfield replacement parts or equivalent. Replacement parts
MUST meet ASABE standards or serious injuries may result. Use of
unauthorized parts will void warranty. If in doubt, contact Westfield or your local
Westfield dealer. Do not modify any components of the Power Swing.
Figure 7.8 Power Swing Maintenance Schedule
Area Maintenance Procedures Frequency
General
While auger is in use, observe the preoperational checklist
found in the Operation section.
Daily
General
Check all operating, lifting, and transport components. Replace
damaged or worn parts before using auger. For replacement
instructions, see the Assembly section of this manual.
Regularly
Drive Chain
Keep drive chain tension adjusted to about 1/4” deflection by
loosening the 2 bolts on the hydraulic or electric motor mount,
then retighten. Apply the same procedure to the chain between
the wheels. The tension for the inter-wheel drive chain is
adjusted by loosening the two bolts on the wheel adjust plate;
re-tighten when finished.
Oil chain frequently enough to keep a light film of oil on it.
Ensure that safety guards are in place and secure before opera-
tion.
Frequently
Hydraulic
Hose
Check hose and hose couplers for leaks, wear, or damage.
Replace if necessary.
Use cardboard when searching for hydraulic leaks.
Frequently
Remote
Transmitter
Ensure that a 9V battery is installed in the back of the remote
transmitter. To install, remove the plastic from around the bat-
tery then place the battery in place in the back of the remote
control.
Before initial
operation, or as
required
Tire
Pressure
Check with a pressure gauge. It is recommended that pressure
be maintained at a maximum of 24 psi (165 kPa).
Monthly,
or as required