Wheatheart X160 Series - Manual (Page 18)

2. S AFETY W HEATHEART - G RAIN A UGERS
X160-85, X160-105, X160-125
18 30875 R0
2.6. TRANSPORT & PLACEMENT SAFETY
• Transport auger in full down position with slight ten-
sion on cable.
• Properly place hitch pin and securely attach safety
chain. Use a type of hitch pin that will not allow
auger to separate from towing vehicle.
• Always attach an SMV (slow moving vehicle) sign
before transporting auger. Equip the auger with the
necessary lights for transportation where required
by law. Always use hazard warning flashers on the
tractor/towing vehicle when transporting unless
prohibited by law.
• Always travel at a safe speed, never exceeding 15
mph (24 km/hr). Reduce speed on rough surfaces
and be cautious when turning corners or meeting
traffic.
• Before raising/lowering/moving the auger, make
sure the area around the auger is clear of obstruc-
tions and/or untrained personnel. Never allow any-
one to stand on or beneath auger while
transporting or placing auger.
• Do not transport auger on slopes greater than 20°.
• Wheels must be free to move when raising or low-
ering auger.
• Never attempt to move auger manually. To do so
will result in serious injury.
• Before moving auger, check and double check for overhead obstructions and/
or electrical wires. Electrocution can occur without direct contact.
• Disconnect PTO driveline from tractor before moving auger or tractor and
secure in transport saddle (where applicable).
• Raise intake feed hopper into transport position and lock hopper lift winch
before transporting or moving auger. Intake feed side of hopper must face
main auger when in transport position.
• Do not operate auger with intake hopper in transport position. This will cause
damage to the u-joint.
2.7. MAINTENANCE SAFETY
• Shut down and lock out all power before attempting maintenance of any kind.
Turn off the tractor and disconnect the PTO driveline and hydraulic hoses
from the tractor.
• After maintenance is complete, replace and secure all safety guards and
safety devices, and if applicable, service doors and cleanout covers.
• Support auger tube before attempting maintenance on the undercarriage
assembly. Auger should be in full down position for maintenance.