Wheatheart X160 Series - Manual (Page 90)

3. A SSEMBLY W HEATHEART - G RAIN A UGERS
X160-85, X160-105, X160-125
90 30875 R0
3.14. INSTALL THE HYDRAULIC WINCH
1. Position the hydraulic winch on the winch mounting plate, and secure it using
three 3/8” washers and three 3/8” locknuts as shown in Figure 3.44.
2. Feed the winch cable through the two lift arm pulleys (at the top of the lift arm
and at the pulley guide), then feed the winch cable under the spool and
connect it to the spool (minimum 3 wraps around the spool, feed cable
through hole in side of spool, and secure with clamp and clamp hardware) as
shown in Figure 3.45.
3. Connect the hydraulic hoses to the winch, as shown in Figure 3.46, and
install pioneer couplings on the hose ends as indicated.
4. Thread both hoses through hydraulic hose upper catches on side of auger
lower tube and boot. Tighten hydraulic hose upper catches slightly to hold
hoses in place.
Figure 3.44 Installing the Hydraulic Winch
WINCH MOUNTING
PLATE
HYDRAULIC
WINCH
3/8” LOCK NUTS [17402]
3/8” FLAT WASHERS
[17392]
POSITION FOR
MANUAL WINCH
5/16” X 1” BOLTS [17125]
AND LOCKNUTS [19980]
LIFT ARM
PULLEY GUIDE