Wheatheart X160 Series - Manual (Page 19)

W HEATHEART - G RAIN A UGERS 2. S AFETY
X160-85, X160-105, X160-125
30875 R0 19
• Use only genuine Wheatheart replacement parts or equivalent. Replacement
parts such as intake guards, pulley guards, PTO driveline shields, winches,
and lift cables must meet ASABE standards or serious injury may result. Use
of unauthorized parts will void warranty. If in doubt, contact Wheatheart or
your Wheatheart dealer.
• Do not modify any auger components without authorization from Wheatheart.
Modification can be dangerous and result in serious injuries.
2.8. SAFETY DECALS
• Keep safety decals clean and legible at all times.
• Replace safety decals that are missing or have become illegible. See decal
location figures that follow.
• Replaced parts must display the same decal(s) as the original part.
• Replacement safety decals are available free of charge from your distributor,
dealer, or factory.
2.8.1. D
ECAL
I
NSTALLATION
/R
EPLACEMENT
1. Decal area must be clean and dry, with a temperature above 50°F (10°C).
2. Decide on the exact position before you remove the backing paper.
3. Align the decal over the specified area and carefully press the small portion
with the exposed sticky backing in place.
4. Slowly peel back the remaining paper and carefully smooth the remaining
portion of the decal in place.
5. Small air pockets can be pierced with a pin and smoothed out using the sign
backing paper.
2.8.2. S AFETY D ECAL L OCATIONS
Replicas of the safety decals that are attached to the equipment and their
messages are shown in the figure(s) that follow. Safe operation of the equipment
requires that you familiarize yourself with the various safety decals and the areas
or particular functions that the decals apply to, as well as the safety precautions
that must be taken to avoid serious injury, death, or damage.
Please review the decals shown. If your auger does not have these decals, they
are available upon request. Please specify which decals you need.