Install the boot on the auger tube, Warning – Wheatheart X160 Series User Manual

Page 47

Advertising
background image

W

HEATHEART

- G

RAIN

A

UGERS

3. A

SSEMBLY

X160-85, X160-105, X160-125

30875 R0

47

3.2.5. I

NSTALL

THE

B

OOT

ON

THE

A

UGER

T

UBE

.\

Note:

The gearbox is sent from the factory filled half way with gear oil. Before further

assembly, check oil level to make certain the gearbox is half full. Add oil if

necessary. Do not use grease.

Note:

The boot flighting comes pre-installed on the end of the lower tube flighting shaft.
1. Remove the 7/8” x 6” bolt and locknut that secures the boot flighting to the

lower shaft flighting. Place the bolt and nut aside for use refastening the

flighting later in the procedure.

2. Position the boot plate against the boot with flat edge facing up (See Figure

3.11), and fasten with two 5/8” x 1-1/2” GR8 bolts at the top of the plate

inserted from the boot side of the flange and 5/8” locknuts.

3. Slip the boot assembly over the boot flight/lower flighting assembly, angling

the boot where required for fit, and rotating the boot flighting during inserting

until the boot, boot attach plate, and lower tube flange are aligned and in full

contact.

4. Attach the boot to the lower tube flange according to the following bolt usage:

a. eight 5/8” x 2” GR8 bolts and locknuts (four on each side),
b. three 5/8” x 1-1/2” GR8 bolts and locknuts (at the top),
c. three 5/8” x 2-1/2” GR8 bolts and locknuts (at the bottom).

5. Fasten the boot flighting to the lower tube flighting using the 7/8” x 6” bolt and

locknut removed in Step 1.

WARNING

Components are heavy and create a crushing

hazard if improperly handled. Be sure to use

proper hoisting equipment and procedures,

and ensure lifting apparatus is secure. Lock

out the lifting apparatus before working

around or under the raised components;

failure to do so may cause serious personal

injury.

Table 3.6 Install the Boot on the Auger Tube

Diagram #

Description

Part #

Quantity

1

Grain transfer boot

20604

1

2

Boot attach plate

20679

1

3

5/8 x 1-1/2”

19590

5

4

5/8 x 2”

19991

8

5

5/8 x 2-1/2”

27589

3

6

5/8” locknut

19600

16

Advertising