Wheatheart X160 Series - Manual (Page 99)

W HEATHEART - G RAIN A UGERS 3. A SSEMBLY
X160-85, X160-105, X160-125
30875 R0 99
Figure 3.53 Power Swing Wiring Diagram
Note:
If the electric power swing will need to be moved from one tractor to another on a
regular basis, 200 Amp automotive booster cable style cable clamps can be
installed at the owner’s own risk and expense.
3.16. INSTALL THE HITCH JACK
The jack is attached to the auger with a pin at the pivot point. To install:
1. Elevate the auger boot (intake end) approximately 2’ (5.08 cm) with a front-
end loader and sling, and install the jack in a vertical position. Secure with
supplied pin.
2. Place a board beneath the jack before setting it on the ground, then lower the
auger until the jack is seated. Remove front-end loader from auger.
Note:
Jack must be rotated 90° for transport or operation.
TRACTOR POWER SWING
LONG ELECTRICAL CABLE
POSITIVE
WIRE
NEGATIVE WIRE AND TERMINAL
GROUNDED TO CHASSIS
POSITIVE WIRE
NEGATIVE
WIRE
RED
BOOT
RECEIVER
BOX
CIRCUIT BREAKER
SHORT
ELECTRICAL
CABLE
WARNING
The jack is designed for raising or lowering
auger hitch only.
Do climb onto auger or place any part of your
body under any part of the auger while it is
supported by the jack, or while the jack is
being operated.