Great Plains 3N4010HDA Predelivery Manual - Manual (Page 10)

8 3N-4010HDA and ADC2350B Great Plains Manufacturing, Inc.
196-444Q 10/10/2008
Install Wheels
Refer to Figure 4
Wheels are supplied as mirror-image assemblies,
mounted for left vs. right hand use. The wheel assem-
blies use identical tires and rims, each side mounted with
the valve stem to the outside. The figure shows tread ori-
entations suggested by Great Plains.
If the customer’s preference is to reverse the tread pat-
tern at the ground, the wheels may be mounted on the
opposite cart side. Do not merely invert the wheels, or
the valve stems will be to the inside.
10. Jack up the tongue end of the cart, and support the
front weldment with jack stands.
11. Remove and save the nuts (16 total):
803-347C WHL NUT, SWIVEL FLG 5/8-18 UNF
from the front caster hub assemblies.
12. Select one:
168-379K 21.5L-16.1 TIRE/18-8 BLT WL LH
Mount the wheel , valve stem side out, on the left
side of the front caster. Secure with eight nuts .
13. Select one:
168-378K 21.5L-16.1 TIRE/18-8 BLT WL RH
Mount the wheel , valve stem side out, on the right
side of the front caster. Secure with eight nuts .
14. Lower front end of cart to ground and block wheels.
15. Jack up the rear end of the cart, and support the rear
of the frame with jack stands.
16. Remove and save the nuts (24 total):
803-183C NUT HEX FLANGE 3/4-16 PLT
from the rear hub assemblies.
17. Select one:
168-377K 30.5L-32 TIRE/27-10 BLT WHL LH
Mount the wheel , valve stem side out, on the left
side of the cart. Secure with ten nuts .
18. Select one:
168-376K 30.5L-32 TIRE/27-10 BLT WHL RH
Mount the wheel , valve stem side out, on the right
side of the cart. Secure with ten nuts .
19. Lower rear end of cart to ground.
Figure 4
Air Cart Transport Wheels
28209
47
20
19
45
18
17
47
20
20
47
19
19
47
45
18
18
45
17
17
45