Great Plains 3N4010HDA Predelivery Manual - Manual (Page 14)

12 3N-4010HDA and ADC2350B Great Plains Manufacturing, Inc.
196-444Q 10/10/2008
Remove Shipping Wheels
Refer to Figure 8
20. Raise the drill. At the front and rear center lift cylin-
ders , replace the small shipping lock channels
with the standard lock channels . Install the stan-
dard lift lock channels at the wing casters.
21. Store the small removed lock channels on the ship-
ping wheel weldments for return to Great Plains.
Note: The longer lock channels are used for normal oper-
ating lift lock, and remain with the drill.
22. Unfold the drill.
23. Place jacks under the rear caster arms (not visible in
Figure). Lift the arms just enough to raise both rear
shipping wheels
off the ground.
Note: Welded loops ( in Figure 8) are provided for hoist-
ing shipping weldments.
24. Remove the nuts, washers and bolts , and plate
that secure the shipping weldment to the rear cast-
ers. Remove the shipping wheel weldment.
25. Lower the rear casters and remove the jacks.
26. Re-assemble the plate to the shipping weldment
for return to Great Plains.
27. Place jacks under the rockshaft axles . Elevate the
rockshaft just enough to raise both front shipping
wheels
off the ground
28. Remove the nuts, washers and U-bolts that
secure the shipping weldment to the rockshaft.
Remove the shipping wheel weldment.
29. Re-assemble the U-bolts to the front shipping
weldment for return to Great Plains.
Figure 8
Shipping Wheels and Locks
28177
2
1
3
7
8
4
1
2
3
6 9
5
4
U
D
L
R
B
F
U
D
F
B
L
R
7
1 2
3
4
6
7 8
8
5
4
7 9
9