Great Plains 3N4010HDA Predelivery Manual - Manual (Page 37)

Great Plains Manufacturing, Inc. Air Drill Pre-Delivery 35
10/10/2008 196-444Q
Blockage Harness Routing
Install Hitch Harness
Refer to Figure 45, Figure 46 and Figure 47 (next page)
116. Select one:
467980130 40’ HITCH HARNESS
This harness is supplied with the air cart, and not
with the drill or blockage kit. it may already be
installed on the drill; if so, the rear end may merely
require re-routing.
The hitch end has a single circular connector. The
rear end has two connectors (the same power/CAN
bus receptacles as WSMB harnesses).
117. Select several ties. Start plug end of harness at
the front drill hitch, leaving slack for tractor hitching.
Route it along the left tongue, and then to Tower 1
(left tower, left wing). Connect power and CAN con-
nectors at Tower 1 WSMB.
Secure hitch harness with ties every few feet (every
meter or so). Additional ties are added later.
Figure 45
Harness Routing (for Blockage only)
28202
F
B
R L
68
69
95
96
70
1 2 3 4 5 6
Harness ID
Callout
Part
Number Description
467980130 40’ HITCH HARNESS
467980141 10’ EXT HARNESS
467980360 3’ REAR HITCH HARNESS
467751320S1 12 ROW HARNESS
467980140 DJ 20’ HARNESS EXT
467980143 INT AG 25’ HARNESS, WSMB EXT
467981201 INT AG HARNESS, WSMB MODULE
68
69
70
94
95
96
98
69
94
98
98
98 98
98 98
94 94 94 94 94
Figure 46
Hitch Harness
27080
68
68
68