Great Plains 3N4010HDA Predelivery Manual - Manual (Page 23)

Great Plains Manufacturing, Inc. Air Drill Pre-Delivery 21
10/10/2008 196-444Q
Tower Elevation
Install Tower Mounts
Start with the outside tower on the left wing.
Refer to Figure 19, Figure 18 and Figure 17 on page 20
63. Select two each:
168-362D NTA35 DIST TOWER MOUNT
806-155C U-BOLT 1/2-13 X 4 1/32 X 3 1/4
and four (4) sets:
804-015C WASHER LOCK SPRING 1/2 PLT
803-020C NUT HEX 1/2-13 PLT
Install both mounts to the top of the 4x2in rear
frame tube, with the longer leg of the angle mount
facing forward. See “Lateral Tower Location (Fig-
ure 17)” table on page 20 for placements from near-
est tool bar end.
Figure 18
Tower Elevation, Left Wing
28204
U
D
R L
x y z
Figure 19
Tower Mounts, Left Wing
27058
16
78
50
39
U
D
F
B
L
R
1
16
78
50
39
16