Great Plains 3N4010HDA Predelivery Manual - Manual (Page 33)

Great Plains Manufacturing, Inc. Air Drill Pre-Delivery 31
10/10/2008 196-444Q
Install Blockage Detectors (Option)
If the drill was not ordered with Blockage Detection (as a
drill option or field-install kit), make sure the harness
steps (page 30) have been completed, and skip to
page 37. The harness installation is different when
Blockage is present, and is covered in this section.
Parts List for Blockage is on page 41. Additional installa-
tion information is found in the DICKEY-john IntelliAg Air
Cart Control Operator’s manual.
Note: The DICKEY-john manual does not include har-
ness routing specific to the Great Plains 3N-
4010HDA, some cable part numbers are slightly
different, and the DICKEY-john manual shows a
CAN bus terminator which is not installed on the
3N-4010HDA (it is provided with and pre-installed
on the ADC2350B air cart).
Refer to Figure 35, Figure 36 and page 23
If the mount plates were not installed at step 66, install
them now.
97. Select six (6):
168-465D DIST TOWER MODULE MOUNT PLATE
At each tower, remove the nuts and lock washers
at the lower U-Bolt , and mount the plate .
Plate orientation is small holes to top, and:
on Towers 1 & 6: extension to drill center
on Towers 2 & 5: extension away from drill center
on Towers 3 & 4: extension to drill rear
Install WSMB
c
s
Start with the left tower (Tower 1).
Refer to Figure 35 and Figure 36
98. Select one:
467981100S1 INTAG WSMB/FLW MNTR MODULE 18R
and two sets:
802-224C HHCS 1/4-20X1 1/4 GR5
804-006C WASHER LOCK SPRING 1/4 PLT
803-006C NUT HEX 1/4-20 PLT
Mount the WSMB on the front of the plate ,
with the connector ports down.
99. Repeat step 98 for the remaining towers.
The WSMB orientation is:
on Wing towers (
Figure 35 ):
connectors down, module to front
on Center towers ( Figure 36 ):
connectors down, module to center
c. DICKEY-john IntelliAg Working Set Member module
Figure 35
Tower 2 Module Mount
27058
82
77
50 39
U
D
F
B
L
R
97
84
86
85
Figure 36
Tower 3 Module Mount
28182
82
50
39
77
97
84
86
85
82
50
39 77 82
97
84
86
85
97 82