Install hydraulic hoses – Great Plains 3N4010HDA Predelivery Manual User Manual
Page 21
Great Plains Manufacturing, Inc.
Air Drill Pre-Delivery
19
10/10/2008
196-444Q
Install Hydraulic Hoses
57. If the hose bracket:
166-701D
PULL BEHIND CART HYD HOSE BRKT
is not pre-installed on the bulkhead
, select it.
Whether pre-installed or not, notice that it has three
slightly different holes:
for sump return hose
for fan/auger pressure hose
for seed monitor
Refer to Figure 16 and Figure 15
58. If the hose bracket:
166-701D
PULL BEHIND CART HYD HOSE BRKT
is not already installed on the bulkhead
,
select it, and two sets:
802-007C HHCS 5/16-18X3/4 GR5
804-009C WASHER LOCK SPRING 5/16 PLT
803-008C NUT HEX 5/16-18 PLT
Secure the bracket
to the bulkhead
with the 4-
hole break facing up and to front.
59. Select one:
806-192C U-BOLT 5/16-18X1 1/2X2 1/2 RND
two sets:
804-009C WASHER LOCK SPRING 5/16 PLT
803-008C NUT HEX 5/16-18 PLT
and four (4):
804-010C WASHER FLAT 5/16 USS PLT
60. Route the sump return hose
(the larger of the two
hoses) through the larger (left end) hole
hose bracket
. Secure with U-bolt
, flat washers
, lock washers
and nuts
.
61. Select two:
800-044C SNAP RING EXT 1 1/2 SHAFT
62. Route the fan/auger pressure hose
to the bracket
hole adjacent to the sump return inlet. Secure with a
snap ring
on either side of the bracket.
Figure 15
Hose Bracket
Ports
28192
74
1
2
3
U
D
L
R
B
F
74
74
73
Figure 16
Rear Hitch Hose Bracket
28190
U
D
F
B
L
R
30
74
38
48
49
79
4
5
38
48
27
74
73
30
48
38
74
73
79
48
38
49
1
74
79
49
48
38
27
27