Great Plains ADC2220 Operator Manual - Manual (Page 119)

Great Plains Manufacturing, Inc. Table of Contents Index Appendix B - Initial Setup 115
2012-10-17 Table of Contents Index 167-073M
Install Loup II Console
Refer to Figure 108
A new ADC2220 cart standard seed monitor system
includes a console
to be mounted in the tractor cab.
Note: Earlier carts included a Loup (I) console.
Installation and setup for Loup (I) begins on
page 119.
Mount the console so that it is easy to observe during planting,
but does not interfere with safe operation of the tractor in the
field or on public roads.
You or your dealer must provide the mounting holes for
the included ball swivel. Your dealer may have alternate
suction cup or clamping brackets available if you prefer to
avoid drilling holes.
Harness cable tie color code:
Console Harness
1. Select one:
318921 LOUP II MULTIPLEX CONSOLE 2220
This includes console , console harness , and:
490003 LOUP II 2220 CLUTCH SWITCH BX
The clutch switch includes a captive harness
that terminates in two 2-pin weatherpak connectors:
a plug (power in), color coded yellow
, and
a receptacle (power out), color coded green .
The yellow lead has a 10A slow-blow fuse .
The console harness has an 8-position receptacle
at one end, and splits into three cables at the other:
a 2-pin weatherpak (power), with blue
cable tie,
a 3-pin weatherpak (monitor), red cable tie, and
a 4-pin CPC connector (for radar, normally unused).
2. Mount the console . Plug the 8-position
receptacle into port J1 of the console. Port J2 is
unused.
Turn the clutch switch to the OFF (0) position.
Figure 108
Console and Tractor-Side Harnesses
29010
4
Y
B
G
Y
R G
B
f
R
13
3
2
1
J1 J2
14
12
5
11
Blue: Console power Green: Clutch power
Red: Drill monitor Yellow: Switched power
14
B G
R Y
14
1 3
12
12 2
Y
G
f
3
B
R
1
3
12