Great Plains ADC2220 Operator Manual - Manual (Page 59)

Great Plains Manufacturing, Inc. Table of Contents Index Loup II Monitor Operation 55
2012-10-17 Table of Contents Index 167-073M
Installation
Refer to Figure 65
Install New System
Install New System allows you to overwrite the existing
Sensor setup. Refer to page 51 for information on
Learning a new system.
Replace a Sensor
Replace a Sensor allows you to replace a bad sensor
without re-learning the system. This refers only to
Learned Sensors; i.e. shaft sensors, hopper sensors, fan
speed sensors and blockage modules.
Add a Sensor
Add a Sensor allows you to add a new sensor without
re-learning the system. This refers only to Learned
Sensors; i.e. shaft Sensors, hopper sensors, fan speed
sensors and blockage modules.
Remove a Sensor
Remove a Sensor allows you to remove a sensor from
your existing system without re-learning the system. This
refers only to Learned Sensors; i.e. shaft Sensors,
hopper sensors, fan speed sensors and blockage
modules. Figure 65
Installation Tasks
29053