Great Plains ADC2220 Operator Manual - Manual (Page 64)

60 ADC2220 Table of Contents Index Great Plains Manufacturing, Inc.
167-073M Table of Contents Index 2012-10-17
Refer to Figure 73
6.
The display is now back at the Speed Settings Menu.
Notice the
Wheel Pulses Per 400 feet
has changed to the calibrated number.
(The number shown is for illustrative purposes only).
Bin Settings
Refer to Figure 74
Bin Settings allow the operator to Enable and Disable the
alarms for Hopper Level Sensor.
By default, these are set to Enable when Hopper
Sensors are Learned.
If your system does not include hopper sensors, this
menu is not available.
Figure 73
New Speed Cal Saved
29060
Figure 74
Configure Bin Alarms
29061