Great Plains ADC2220 Operator Manual - Manual (Page 67)

Great Plains Manufacturing, Inc. Table of Contents Index Loup II Monitor Operation 63
2012-10-17 Table of Contents Index 167-073M
Refer to Figure 79
2.
Begin planting a normal speed. You must be planting
seed during this entire process.
Refer to Figure 80
3.
As you drive the display shows the number of rows
that have been calibrated on the second line (none
so far in the figure). The third line shows the Total
number of rows.
Note: The number 32 is for illustration purposes only.
Your number will be different.
Figure 79
Begin Planting
29066
Figure 80
Rows in Calibration
29067