Great Plains ADC1150 Operator Manual - Manual (Page 4)

2
Important Safety Information
ADC1150 Air Drill Cart 167-101M 6/15/05
Great Plains Mfg., Inc.
Transport Machinery Safely
▲
Latch auger properly before trans-
porting.
▲ Maximum transport speed for
implement is 20 mph. DO NOT
EXCEED. Never travel at a speed
which does not allow adequate
control of steering and stopping.
Some rough terrains require a
slower speed.
▲ Sudden braking can cause a
towed load to swerve and upset.
Reduce speed if towed load is
equipped with brakes.
▲
Comply with state and local laws.
▲
Do not tow a load that weighs
more than 1.5 times the weight of
the towing vehicle.
Use Safety
Lights and Devices
▲
Slow moving tractors, self-pro-
pelled equipment and towed
implements can create a hazard
when driven on public roads. They
are difficult to see, especially at
night.
▲
Flashing warning lights and turn
signals are recommended when-
ever driving on public roads. Use
lights and devices provided with
implement.
Practice Safe Maintenance
▲ Understand procedures before
doing work. Use proper tools and
equipment.
Refer to “Mainte-
nance and Lubrication,” page 46
for additional information.
▲ Work in a clean, dry area.
▲ Lower the implement to the
ground, put tractor in park, turn off
engine, and remove key before
performing maintenance.
▲
Allow implement to cool completely.
▲ Do not grease or oil implement
while it is in operation.
▲ Disconnect battery ground cable
(-) before servicing or adjusting
electrical systems or before weld-
ing on implement.
▲
Inspect all parts. Make sure parts
are in good condition and installed
properly.
▲ Remove buildup of grease, oil or
debris.
▲ Remove all tools and unused
parts from implement before oper-
ation.
▲ Keep ladder steps clean and free
of oil, mud or other slippery sub-
stances that could cause falls.
Use A Safety Chain
▲
Use a safety chain to help con-
trol drawn machinery should it
separate from the tractor draw-
bar.
▲ Use a chain with the strength
rating equal to or greater than
the total weight of the towed
machinery.
▲ Attach the chain to the tractor
drawbar support or other speci-
fied anchor location. Allow only
enough slack in the chain to per-
mit turning.
▲ Do not use safety chain for tow-
ing.