Bins – Great Plains ADC2220 Predelivery Manual User Manual
Page 29
3/3/2006
167-088Q-RUS
27
Cart Assembly
Figure 53
View of Front Hopper from Above
Figure 54
View of Rear Hopper from Above
Front
Rear
Metering
Device
23257
Front
Rear
Metering
Device
23256
Bins
Refer to Figures 53 and 54
1.
Plastic tubes should be installed inside the
bins - two per bin.
2.
Install plastic tubes from rear of bin to rear
of metering device in front bin.
3.
Install plastic tubes from front of bin to rear
of metering device in rear bin.
NOTE: It is important that the plastic tubes are
installed properly to equalize air pressure. If
they are not installed correctly, the implement
may produce undesirable results.
Bin Lids
Refer to Figure 55
1.
Place bin lid on top of bin. Bin lid hinge will
bolt to bin on opposite side across from u-
bolt.
2.
Attach bin lid to top of bin using bolts and
flat washers.
3.
Secure lid with flat washers and lock nuts.
4.
Repeat steps 1-3 to attach second bin lid to
other bin.
23070
Figure 55
Bin Lid