Great Plains ADC2220 Predelivery Manual - Manual (Page 37)

3/3/2006 167-088Q-RUS
35 Implement Assembly
24118
24119
Figure 74
Secure Gauge Wheel and Caster Retainer Cap
Figure 73
Gauge Wheel
Refer to Figure 73
3. Slide pivot thrust washers down shaft of
gauge wheel.
4. Attach gauge wheel to parallel arm lift assem-
bly by sliding gauge up through assembly.
Refer to Figure 74
5. Place caster retainer cap on top of gauge
wheel.
6. Secure caster retainer cap to gauge wheel us-
ing bolt and lock washer.
7. Repeat steps to install gauge wheel on oppo-
site side of implement.
Parallel Arm Gauge Wheel Hydraulics
Refer to Figure 75
1. Remove hydraulic cylinder that is secured to
frame via bungee cord or tie-down strap.
NOTE: Use the cylinder closest to the
gauge wheel each gauge wheel.
2. Remove pin, washer, and cotter pin from base
end of hydraulic cylinder.
3. Align base end of hydraulic cylinder with
frame.
4. Insert pin through cylinder and frame.
5. Slide washer on pin and secure with cotter
pin.
24120
Figure 75
Gauge Wheel Hydraulic Cylinders