Great Plains ADC2220 Predelivery Manual - Manual (Page 38)

167-088Q-RUS 3/3/2006
ADC2220 & NTA 3510 36
Refer to Figure 76
6. Using pin, pull rod end of cylinder until cylin-
der can be secured to eyebolt weldment.
7. Once hydraulic cylinder and eyebolt weldment
are aligned, insert pin completely.
8. Slide washer on pin and secure with cotter
pin.
9. Complete previous steps on opposite side of
implement to attach hydraulic cylinder to
gauge wheel.
24121
Figure 76
Gauge Wheel Hydraulic Cylinder
Rockshaft
Refer to Figure 78
NOTE: Rockshaft installs on opposite
side of center frame from dual guage
wheels.
1. Align rockshaft with holes in center
frame.
Figure 78
Attach Rockshaft
24122
24139
Dual Gauge Wheel Tires
Refer to Figure 77
10. Reattach lift straps to implement frame and
raise frame so that gauge wheel tires can be
installed.
11. Remove wheel nuts from gauge wheel hub
assembly.
12. Attach gauge wheel tire to gauge wheel hub.
13. Secure tire to hub with previously removed
wheel nuts.
14. Repeat process on second tire on gauge
wheel.
15. Complete steps 10-14 to install gauge
wheels on opposite side of implement.
24140
Figure 77
Attach Gauge Wheel Tires