Great Plains YP825A3P Operator Manual - Manual (Page 56)

52 YP4-6-825A3P Table of Contents Index Great Plains Manufacturing, Inc.
401-652M Table of Contents Index 2013-05-28
Row-Unit Opener Disk Adjustments
25 Series openers have three adjustments:
1. planting/seed depth
2. opener disc to disc clearance
3. gauge wheel/opener disk clearance (page 53)
Setting Planting Depth
Refer to Figure 51
The “T” handle sets planting depth by limiting the how
high the side depth gauge wheels ride relative to the
opener disks. The position of the seed tube itself is fixed
relative to the disks, and is not adjusted.
To adjust seed depth, pull the “T” handle up and back,
move it forward or aft, and set it back in a different pair of
holes in the scale.
• For shallower planting, move the “T” handle
forward.
• For deeper planting, move the “T” handle back.
Opener Disc Contact Region
Refer to Figure 52 and Figure 53
Opener disc angle and stagger is not adjustable, but
disc-to-disc spacing is, and may need attention as discs
experience normal wear. Spacers will need to be reset
when blades are replaced.
The ideal spacing causes the blades to be in contact for
about one inch
. If you insert two pieces of paper
between the blades, they should slide to within zero
(touching) to 1.5 inch (3.8 cm) of each other. If zero, the
gap between the blades should not be significantly
greater than the thickness of two sheets of paper.
If the contact region is significantly larger or there is a
large gap, it needs to be adjusted by moving one or more
spacer washers.
Adjusting Disc Contact
1.
Raise the planter and install lift cylinder locks.
2. Remove the side gauge wheels on the row unit in
need of adjustment.
3. Remove the bolt retaining the opener disc on
one side. Carefully remove the disc. Do not lose the
hub components and spacer washers
, .
4. To reduce the spacing between the discs (the normal
case), move one spacer washer from the inside
to
the outside of the disc.
5. Re-assemble and check disk contact.
Figure 51
Opener Adjustments
29983
2
3
1
1
1
1
1
Figure 52
Opener Disc Contact Region
26127
4
5
4
Figure 53
Opener Disc Spacers
26128
9
8
6
7
5
6 7
8 9
8
9