Great Plains YP825A3P Operator Manual - Manual (Page 80)

76 YP4-6-825A3P Table of Contents Index Great Plains Manufacturing, Inc.
401-652M Table of Contents Index 2013-05-28
Meter Clean-Out
Refer to Figure 81
The 817-811C seed collection accessory (funnel ) may
be attached to the housing of the seed meter, freeing
your hands for other tasks during clean-out.
Note: The funnel does not fit rows to the left of gauge
wheels on twin-row planters. Use vacuum or tarp
collection on those rows.
Note: It may be necessary to raise a twin-row planter to
obtain clearance for the funnel. Secure with blocks
or jack stands if the planter is raised.
1. Close the seed inlet shutter on the meter (page 55).
This minimizes the seed volume at disk removal.
2. Remove the rain cover (page 55). The funnel cannot
be snapped in place with the cover installed.
3. Align the left (rear) end of the funnel lip with the
top of the lower (rear) cover latch ear. Place the right
(front) end of the funnel lip
between the meter
housing and the seed tube.
4. Rotate the funnel forward until the slot at lip center
engages a tab on the bottom center of the meter
housing.
5. Remove the seed (page 58).
6. Slowly open the seed shutter (page 55) to empty the
seed up to the slide gate.
7. If seed remains in the hopper, use the slide gate to
control the volume of flow.
Refer to Figure 80
8. Clean seed from all brushes (shop vac
recommended).
9. Inspect brushes (page 77).
10. Rotate funnel clockwise, remove and empty.
11. For imminent operations:
Install next seed wheel or blank disk (page 59) for
operations. Set inlet shutter for next seed (page 55).
12. For storage:
Close seed inlet shutter. Leave disk out.
Close Y-tube (if any).
13. Re-install rain cover (page 55).
At end-of-season clean-out, inspect a few seed meter air
release screens. If they require cleaning, consider
cleaning all rows.
Alternate Meter Clean-Out
To use a shop vacuum cleaner, with narrow hose nozzle,
to clean out a meter:
• Close the seed shutter.
• Release the meter clamp, hold the disk against the
meter.
• Tip the top of the disk away from the meter.
• Insert hose nozzle and remove seed.
• Open shutter to allow seeds in inlet and drop hose to
flow to vac nozzle.
Figure 80
Brush Inspection
29608
5
6
7
1
Figure 81
Funnel Positioned and Engaged
29612
1
2
3
4
3
4