Install second marker sections, Install marker hinge pins, Install marker shear bolts – Great Plains YP1625A Operator Manual User Manual
Page 147
Great Plains Manufacturing, Inc.
Appendix B - Pre-Delivery
143
2013-08-13
401-625M
Install Second Marker Sections
Refer to Figure 148 (C: to Center; W: to Wing)
For each wing:
14. Select one of:
113-010H PLANTER MARKER 2ND SECTION LH
113-031H 12 ROW MARKER 2ND SECTION LH
113-481H YP1625 36TR MARKER 2ND SEC LH
or (not shown):
113-013H PLANTER MARKER 2ND SECTION RH
113-032H 12 ROW MARKER 2ND SECTION RH
113-480H YP1625 36TR MARKER 2ND SEC RH
Identify the whether the arm is LH or RH, depending
on the wing involved.
Install Marker Hinge Pins
15. Select one each:
113-798D MARKER SHEAR PIVOT PIN
and two sets:
804-029C WASHER FLAT 1 SAE
805-058C PIN COTTER 3/16 X 2
Drive one cotter pin
through an end hole (the top
hole) of the shear pivot pin
. Add a washer
under the cotter.
Heavy Overhead Object Hazard:
Use adequate lifting means. Use multiple attachment points.
Use extra personnel to control the load. The arm section may
weight up to 300 pounds (135 kg), and does not balance at the
center of its considerable length. if it falls, or you lose control
of the load, workers could suffer serious or fatal injuries.
16. Orient the arm (
or
) with the shear pin hole to
the rear (flat plate at the hinge end up, angled edge
of plate forward, and the center tube below).
Hoist the arm, resting the single-tube end in the
transport rest, and aligning the shear pivot tube with
the shear pivot holes in the hinge
.
Insert a shear pin
. Secure with second washer
and cotter
.
Install Marker Shear Bolts
Refer to Figure 149
17. Select one each:
802-130C HHCS 1/2-13X2 1/2 GR5
803-019C NUT LOCK 1/2-13 PLT
Insert the shear bolt
from the wing end of the
hinge
. Secure with lock nut
.
Figure 148
LH Marker Arm 2nd Section
34385
40
11
39
15
4
U
D
C
W
F
B
39
40
11
11
11
12
12
12
15
39
40
40
15
39
Figure 149
LH Marker Shear Bolt
24408
U
D
C
W
F
B
30
25
11
12
15
39
40
25
30
25
30