Parking, 3 point hitch – Great Plains YP1625A Operator Manual User Manual

Page 50

Advertising
background image

46

YP1125A & YP1625A

Table of Contents

Index

Great Plains Manufacturing, Inc.

401-625M

Table of Contents

Index

2013-08-13

Parking

For information on long-term storage, see “Storage” on
page 47.

1.

If equipped with fertilizer, flush system and secure
pump against corrosion.

2.

Fold planter. see “Folding the Planter” on page 25.

Note: Be sure to install cylinder lockup channels. Failure

to do so may result in injury and/or damage to the
planter.

3.

Park planter on a level, solid area.

4.

To prevent rolling, block tires securely.

Roll-Away Hazard:
DO NOT unhitch planter while on a steep slope. Always block
tires when unhitching from tractor. There is not enough weight
on parking stand(s) to anchor planter on a slope.

Refer to Figure 55

3 Point Hitch

5.

Remove pin

holding main parking stand

in “UP”

position. Swing stand down. Pin stand in parking
position. If the ground is soft, place a board or plate
under the stand.

6.

Remove wire snap lock pin

from innermost hole

on park stand mount, or remove both pins if stand
was inverted. Swing support stand from underneath
crossbar weldment, or invert to foot down.

7.

Secure 3-point prop stands by using two pins on
each stand.

8.

Lower tractor 3-point until planter is resting on
parking stand.

Hydraulic Tongue Hitch

9.

Remove pin

holding main parking stand

in “UP”

position. Swing stand down. Pin stand in parking
position. If the ground is soft, place a board or plate
under the stand.

10. Use tongue cylinder to lift planter high enough to

fully swing down parking stand. Insert locking pin in
parking stand.

11. Use tongue cylinder to lower planter onto parking

stand. Pin parking stand.

12. Use tongue cylinder to lift tongue off tractor draw bar.

Either Hitch

13. Set all implement hydraulic circuits to Float to relieve

pressure in lines.

14. Shut down hydraulics. Unplug hydraulic lines from

tractor. Do not allow hose ends to rest on the ground.

15. Unplug planter light cable from tractor.

16. Unplug monitor harness from console.

17. 3-point: Unhook tractor from planter hitch.

18. Pull tractor away.

Figure 55

Jack and 3-Point Prop Stand

22814
27282

1

2

4

3

1

2

3

4

1

2

Advertising
This manual is related to the following products: